#2137 Stay-in-place cap
A modern approach for
sealing concrete slabs! 
Aesthetically appealing, this
one-step plastic cap provides
for expansion and contraction
while forming a water resistant
seal.  This UV resistant cap
saves contractors time and
money!  No need to remove
cap and caulk.  Available in black & gray.

#0658 Removable cap
A black removable cap
that snaps onto the
KEY-LOC Joint prior to
pouring.  Cap is removed
after concrete is set to
create a 13/32” wide void
for sealant.  Cap may be
re-used as many as 15 times.

#1886 Ribbed cap
A ribbed black adapter cap
for use with removable polystyrene cap that snaps
onto the KEY-LOC Joint
prior to pouring.  After
concrete has set, top half
of polystyrene cap is
removed, and depending
upon polystyrene cap
choice, either a 1/2” x 1/2”
or a 3/8” x 1/2” void is
created for sealant

#3017 Clean-Strip Cap The easiest, most economical way to finish concrete slabs with a water resistant seal. Install Key-LOC Joint with our Clean-Strip Cap applied to the top edge. Pour and finish concrete slab. Peel off top of Clean-Strip cap for the most aesthetically appealing controlled slabs. No need to strip or caulk.

250 ft./roll
20#/roll

 400 ft./roll
23#/roll

250 ft./roll
20#/roll

200 ft./roll
20#/roll